Connections - Bosch UPH-2D Series Instruction Manual

28 en | Configuring the Device
7.4

Connections

Please take note of the particular UPH model that you have installed. All three versions, UPH-
Z, UPH-2D, and UPH-3D Series, support Bilinx and Biphase telemetry control, i.e.: PTZ.
The camera menu setup of UPH-Z Series is done via the OSD, i.e.: AUX ON - 200 - Enter. The
camera menu setup of UPH-2D and UPH-3D Series is done via two different AUX commands,
i.e.: AUX ON - 46 - Enter (Dinion
tion menu). See Figure 10.1 for more information about keyboard commands.
Bilinx is a Bosch two-way communication protocol that allows remote control, configuration,
and updates over a video coax cable. Bilinx is available on all UPH models.
Biphase is used for communicating telemetry (control) and set up information with the UPH-
Series units. Biphase does not pass the video signal from the UPH-Series units, so a separate
video coax cable is required. Biphase should be wired with Belden 8760 or equivalent.
Biphase is available on all UPH models.
Note: If the UPH is the only unit connected, or the last unit in a daisy chain configuration, then
turn ON dip-switch 1 of Biphase + Bilinx to terminate the data line. Turn OFF dip-switch 1 of
Biphase + Bilinx for each UPH in a daisy chain (i.e. unterminated). A maximum of four (4) UPH
units can be daisy chained together.
F01U.073.990 | Version 1.0 | 2007.07
LTC5136 or
equivalent
RS-232
XF
main menu) and AUX ON - 801 - Enter (Dinion
Interface
Box
CCTV Monitor
Instruction Manual
High Speed Pan/Tilt System
Biphase
Video
Bosch Security Systems
XF
installa-
UPH Series:
unitized pan/
tilt head