Press the front panel squarely into position until the tabs
2.
lock the panel in place.
Replace the access cover (see "Replacing the Access
3.
Cover").
4.
After securing your system, reboot it and run the Setup
program to set the new configuration.
EXTERNAL OPTIONS
This subsection includes installation procedures for the
following external options:
T
parallel printer
T
serial devices.
Connecting a Parallel Printer
NOTE
sure the printer is set up correctly. Follow the setup
instructions that came with the printer.
Connect a parallel printer to the system as follows.
1.
Turn off power to the system and printer.
2.
Connect the printer cable to the printer port on the rear
of the system unit (see the following figure).
3.
Secure the cable with the screws provided.
Connect the other end of the cable to the printer.
4.
Turn on the printer and the computer.
5.
Before connecting a printer to the system, be
Installing Options 5-35