Adding External Options; Connecting A Parallel Printer - NEC POWERMATE VE ETC Manual

NOTE
remove the protective cardboard insert from the
drive.
Run the Setup program to set the new configuration.
6.

ADDING EXTERNAL OPTIONS

This subsection includes installation procedures for the
following external options:
T
parallel printer
T
serial devices.

Connecting a Parallel Printer

Connect a parallel printer to the system as follows.
NOTE
sure the printer is set up correctly. Follow the setup
instructions that come with the printer.
1. Turn off power to the system and printer.
2. Connect the printer cable to the printer port on the rear
of the system unit (see the following figure).
3. Secure the cable with the screws provided.
4. Connect the other end to the printer.
If your printer requires ECP support, see "Integrated
5.
Peripherals Menu" in Chapter 4.
If a 1.2-MB diskette drive was installed,
Before connecting a printer to the system, be
Installing Options 3-43