Table of Contents
Advertisement
!
Turn off the system before you change any jumper
settings.
2.
Remove the access cover (see "Removing the Access
Cover" in Chapter 5).
3.
Locate the Configuration jumper (J8E1) on the system
board (see "Locating the Jumper" in the previous
subsection).
4.
If necessary, remove any installed expansion boards to
access the jumper (see "Removing an Expansion
Board" in Chapter 5).
Remove the jumper block from pins 1-2 and set it on
5.
pins 2-3. We recommend that you use needle nose
pliers to move a jumper.
6.
Replace the access cover (see "Replacing the Access
Cover" in Chapter 5).
7.
Connect system power cables and monitor.
Power on the system.
8.
The system enters Setup and the Maintenance menu
appears. You can disable the user and administrator
passwords.
If you removed the jumper, the system attempts to
recover the BIOS. A recovery diskette is needed.
9.
Power off, unplug the system and monitor, and remove
the access cover.
10.
Remove the jumper block from pins 2-3 and replace it
on pins 1-2.
WARNING
Setting System Board Jumpers 6-3
Advertisement
Table of Contents
