Table of Contents
Advertisement
Replace the access cover (see "Replacing the Access
5.
Cover).
MEMORY UPGRADE
Your system comes with 32 MB to 256 MB of main system
memory factory-installed in up to two 168-pin sockets on
the system board. The sockets support Dual In-line Memory
Modules (DIMMs).
You can install memory in one or two sockets. The size and
speed of the DIMMs can vary between sockets. Single- and
double-sided DIMMs are supported.
Before installing memory, read the detailed explanation of
memory types and configuration options in Appendix B.
Depending on product upgrade availability, your system
memory can be upgraded to a total of 256 MB. When
upgrading your system memory, note the following
conditions:
T
Be sure to use 168-pin 3.3V DIMMs with gold-plated
contacts.
T
Bus speed of 66 MHz only is supported.
T
Non-Error Correcting and Checking (64-bit) DIMMs
are supported.
NOTE
SDRAM DIMMs must meet the Intel 4-clock,
66-MHz, unbuffered SDRAM DIMM specification for
64-bit SDRAM.
Use the following procedure to:
T
Check the memory installed in the system
5-12 Installing Options
Although memory size and type may vary, the
Advertisement
Table of Contents
