Table of Contents
Advertisement
Installing the SuperScript Software
The SuperScript software installation program
analyzes your system configuration, installs the
SuperScript software and fonts, and makes the
necessary changes to the Windows startup files. As
shown in the following tables, there are two ways to
install SuperScript software:
•
Custom Installation, which you can do either from
the installation diskettes or from the CD.
•
Easy Installation, which must be done from the
diskettes.
Note: If you need to make full featured SuperScript
software installation diskettes, you can do it from
the SuperScript for Windows 95 installation CD as
follows. (You need seven empty diskettes. The
following instruction assumes the CD drive is drive
d and the diskette drive is a.)
At the DOS prompt, type
1. d:
2. cd \software\win95\makedisk
3. makefd a:
Then follow the instructions on your screen to make
the installation diskettes.
04 Ch.3 Installing
3
Chapter 3: Installing the Software
SuperScript Installation Dialogs
The installation dialogs presented during the setup
process are the same whether you install using
diskettes or the CD.
1.
Once installation starts, the Welcome to
SuperScript setup screen appears, as shown in the
following figure. This screen is displayed for
approximately five seconds.
The first installation dialog box appears. You can
choose Easy Installation or Custom Installation.
96.9.24, 11:16 AM
3—3
Advertisement
Table of Contents
