Parallel Cable; Power Cord - NEC SuperScript 660plus User Manual

Parallel Cable

Connect the parallel cable as follows:
1. Switch OFF power to the printer and to the
computer.
Caution! To protect your printer and computer from
possible damage, make sure the power switch is
OFF.
2. Plug the parallel cable into the printer, then secure
the lock springs.
3. Connect the other end of the parallel cable to the
computer.
03 Ch.2 Setting Up 13
Chapter 2: Setting Up and Using the Printer

Power Cord

Connect the power cord as follows:
1. Switch OFF power to the printer.
2. Plug the power cord into the power plug on the
rear panel of the printer.
3. Plug the other end of the power cord into a
properly grounded electric outlet.
Caution! Do not
connect the power cord
to the auxiliary outlet of
your computer.
96.9.24, 11:10 AM
2—13