Table of Contents
Advertisement
Chapter 3: Installing the Software
SuperScript Software Installation
This section describes the steps to set up the
hardware and software necessary to configure your
printer. Installation includes the following steps:
•
Pre-installation
•
Installation of the SuperScript software
•
Testing and verifying the installation
Some procedures described below, such as disk
defragmention, may not be necessary for your PC
configuration. The installation description provides a
general approach. Your configuration may provide an
alternate set of selections, such as an installation
folder.
To install both GDI and PCL you need 40 MB space
on your hard disk.
3—2
04 Ch.3 Installing
2
Table 3-1 Pre-Installation Steps
COMMENT
ACTION
1. Remove the current
Click Start, then click Run.SuperScript software if it
installed in the PC. In Windows 95, type
C: \SSCRIPT\NECDELETE.EXE
in the command line box. Press Enter.
In Windows 3.1 and 3.11, if your current
SuperScript software is SuperScript
Network and PS option kit software, type
C: \NECSSFW\WSREMOVE.EXE in the
command line box. Press Enter.
2. Defragment the disk
You can use Disk Defragmenter in Windows 95.
Refer to your Windows 95 documentation. This is
recommended, but not generally necessary.
Note: Be sure to remove the current SuperScript software
prior to installing the SuperScript 660plus in order to avoid
installation problems. Appendix A, Troubleshooting,
provides some instructions on what to do if you encounter
installation problems.
96.9.24, 11:15 AM
Advertisement
Table of Contents
