Installing Superscript Printing Software - NEC SuperScript 610 User Manual

INSTALLING
SUPERSCRIPT
PRINTING
SOFTWARE
Silentwriter SuperScript 610 includes a software
installation program to make the setup easier. The
installation program analyzes your system configura-
tion, installs the SuperScript software and fonts, and
makes any necessary changes to Windows startup
files.
Once you have started the NEC SuperScript setup
program, you can cancel the installation at any time.
Just click on the Cancel button that appears in the
setup program window.
NOTE: You must have a minimum of 4 megabytes
of RAM and 8.5 megabytes hard disk space. The
following information shows how to identify the
available space on your hard disk. You may skip
this page if you are sure that your system meets both.
To verify your available disk space,you can try the
following:
1. From the C:\ prompt (or whichever drive you
intend to install the SuperScript software), type
DIR.
2. Examine the disk space information given near
the end of the screen.
DOS <DIR> 06-15-93
CONFIG SYS 30 06-15-93
50 file(s)
113483442 bytes free
3. The number appearing in bold here is the relevant
information you need to look for on your screen.
Make sure your number is greater than 8,910,000.
Setting Up
.
.
.
9:00a
9:15a
.
.
.
12345678 bytes
2–27