Table of Contents
Advertisement
Chapter 2: Setting Up and Using the Printer
Precautions for Installation
Installation Site
To ensure a long life for the printer, it is important to
select an appropriate installation site. Choose a site that
meets the following requirements:
•
A well-ventilated place.
•
An area that will not generate ammonia or other
organic gases.
•
A power outlet is nearby, so that the power cord
can be plugged in and unplugged easily.
•
An area free from direct sunlight.
•
A place that is out of the direct air stream of an air
conditioner, heater, or ventilator and is not subject
to very high or very low temperature or humidity.
•
A stable and level location not subject to undue
vibration.
•
A place free from anything that could obstruct the
printer's heat exhaust duct.
•
There are no curtains or other fabrics nearby that
could catch fire.
•
There is no possibility of being splashed with
water, coffee, or any other liquid.
•
The area is dust-free.
Power Source
The power source voltage requirements are as follows.
•
Voltage fluctuation: 110 V 60 Hz
•
Frequency fluctuation: Within ±0.3% 110V 60 Hz
2—2
03 Ch.2 Setting Up
2
Observe the following precautions when establishing
the power source for your printer:
•
Use a power source with little voltage and
frequency fluctuation.
•
Use an outlet with the specified voltage capacity
only.
•
Be sure to insert the power cord all the way into
the outlet. The outlet should be located near the
printer and be easily accessible, so that the power
cord can be unplugged immediately when
necessary.
•
Be sure that outlet is visible, and not hidden
behind the printer or any other office equipment.
•
If any other electrical equipment uses the same
outlet, make sure that the capacity of the outlet is
not exceeded.
•
If an extension cord is needed, use one with a
capacity greater than the power consumption of
the printer. A cord that falls short of the capacity
requirements could cause a fire.
•
Never connect any other appliances or machines
by means of a multiple socket to the outlet you use
for the printer.
Grounding
Always ground the printer to prevent electrical shocks
in the case of electrical leakage. If you are unable to
make grounding connections consult your NEC
Technical Support at 1-800-632-4650 (toll free).
96.9.24, 11:05 AM
Advertisement
Table of Contents
Need help?
Do you have a question about the SuperScript 660plus and is the answer not in the manual?
Questions and answers