Table of Contents
Advertisement
Using Separation
and Deletion for
bar code zones
6-16
When a bar code is detected, you can use the Separation and Deletion tab to
enable the following options:
• Separate batches
• Separate documents
• Create attachments
Choose the Separation and Deletion tab to set any of these options.
• No separation—if you this option, you must indicate what level the bar code
is located on. Bar codes can be found on one of the following levels:
- Batch level—bar codes that are located on the Batch level or that
separate batches are available for Batch and Document indexing.
NOTE: Batch level bar codes are only read when they are present on a
Batch Header page. A Batch Header page exists whenever batch
separation is defined using patch codes or bar codes (at least one
bar code zone in the application is configured for Batch separation).
See the following section, "Separating batches."
- Document level—bar codes that are located on the Document level or
that separate documents are available for Document indexing. They are
not available for Batch indexing.
- Page level—page level bar codes to be used for Page level indexing are
not yet supported in Capture Software.
A-63054 February 2004
Advertisement
Table of Contents
