Table of Contents
Advertisement
11 System Administration
Program Properties
A-63054 February 2004
Any Capture Software user who has Administrator privileges can access the
Program Properties dialog box to change any of the following settings.
Multi-user path—allows you to specify a folder/subdirectory on a server to
share applications and page templates by several computers with Capture
Software installed.
NOTES: Before changing your multi-user path, Capture Software first checks
whether the specified subdirectory has already been established as a
multi-user path. This is indicated by the existence of an MVCS.LCK
file in the subdirectory. If the subdirectory is not a multi-user path, a
warning message appears with the option of continuing or canceling
the changing of the multi-user path.
Capture Software will not copy or move applications and page
templates to the new multi-user path. Any applications or page
templates in the old multi-user path still remain. To avoid confusion
with your Capture Software installation, it is recommended that you
uninstall Capture Software and then re-install it, specifying the new
multi-user path at installation time instead of changing the multi-user
path in System Administration.
Workstation name and ID—enter a unique workstation name and ID for each
computer that has Capture Software installed.
Disk Space warning level—Capture Software will warn you whenever the
amount of free hard disk space falls below this warning level. Enter the number
of Mbytes for the warning level.
Font size—allows you to choose a font size for the Scanner bar, Document
Title bar, Image Title bar, and Status bar.
User profiles—press this button to set up users and user groups. See the
section entitled "User profiles" for more information.
NOTE: User profiles are not available for Capture Software Lite for i50/i60/i80
Scanners or Capture Software Lite for i200 Series Scanners.
Demonstration mode—should always be enabled when you run Capture
Software without an attached hardware key. When you use a production CD to
upgrade Capture Software from the Demonstration version to production, you
must uncheck the box to disable Demonstration mode.
NOTES: Low Volume Capture Software Lite (Scanner 1500 and Scanner
2500), Capture Software Lite for i50/i60/i80 Scanners, and Capture
Software Lite for i200 Series Scanners do not require a hardware key
to run in production. However, features not supported by Capture
Software Lite (e.g., bar code reading, OCR indexing, etc.) can be
demonstrated by enabling Demonstration mode.
When you change the Demonstration mode setting, Capture Software
automatically closes. You must restart Capture Software in order for
the setting to take effect.
11-1
Advertisement
Table of Contents
