Table of Contents
Advertisement
Recovering from
a paper jam
Calibration
A-63054 February 2004
Under certain conditions, a paper jam can occur. Follow these steps to clear
the scanner and restart Capture Software.
1. Clear any paper from the scanner by following the guidelines described in
the User's Guide for the scanner you are using.
2. Make sure that the top and/or bottom of the scanner are completely closed,
if you had to open them to clear the jam.
3. Wait until the scanner is ready (e.g., on the Scanner 3500, the yellow light
is off and the green Ready light has stopped flashing).
NOTE: Check the screen to verify the last complete image you received from
the scanner before the paper jam. Restart scanning from that point.
4. Click the green Start button on the Scanner bar in the main window.
NOTE: For the i200 Series Scanners, the red indicator light remains on until
the scanner is restarted. If the jam was properly cleared, the red
indicator light will go out and the green indicator light will illuminate.
Calibration optimizes the optical system of your scanner in order to achieve the
best overall quality of scanned images. Frequent calibration is not needed or
recommended. However, if you do need to calibrate the scanner (for example,
poor image quality), follow the steps below.
1. Clean the imaging guides properly (e.g., see the scanner's User's Guide
for procedures).
2. Obtain a proper calibration target.
Use a clean, blank sheet of paper with a matte surface (not glossy). Make
sure that the target is wider than the documents to be scanned. It is best to
use the square calibration target available from Kodak.
NOTE: For the i800 Series Scanners only: You must use the special
black-and-white calibration target provided with the scanner.
3. Select Scanner>Calibration in the Capture Software main window.
NOTES: For the i50, i60, and i80 Scanners and the Scanner 1500 and
Scanner 2500, scanner calibration is not necessary and therefore is
not available through Capture Software.
For the Scanner 5500, Scanner 7520, and Scanner 9520, calibration
is available only through the scanner operator panel and is required
every time the scanner is powered up.
For the Color Scanner 3590C and Color Scanner 4500, select
Scanner>Color Calibration for color image quality issues.
A prompt appears.
4. Place the calibration target in the scanner ADF.
5. Click OK.
2-9
Advertisement
Table of Contents
