Table of Contents
Advertisement
Using the Tool bar
A-63054 February 2004
Button
Blank—you can blank out a specific part of an image by using
the Blank tool. This is useful to clean up images or remove
confidential information.
Crop—allows you to draw a rectangle around a specific area of an
image and discard any information outside the rectangle. Use this
tool to keep only the significant part of an image.
Move—use the Move tool to move a page or a consecutive range
of pages to another location. You can also set the Move tool to
move an image or a consecutive range of images.
Split—allows you to split a document into two documents.
Print—allows you to print a complete document, or specific images
within a document.
Copy image—allows you to copy a complete image to the
Windows clipboard.
Copy area—allows you to copy an area of an image to the
Windows clipboard.
Following are procedures for using the Tool bar options.
Re-Append images
Insert image
You can insert additional images into a scanned document with the Insert
image tool.
To use the Insert image tool:
1. Select the Insert image tool (or press Insert).
2. Click on the page (front image of the page) where you want to
insert images.
The images will be inserted before this page. The selected page and all
following images are placed in a temporary buffer. The Re-Append
images tool appears at the left side of the Tool bar.
When you click on the rear of a page that also contains a front, the
message Inserting images between a front and a rear of a page is not
allowed appears.
3. Scan the images you want to insert.
4. When you have finished scanning, recall the images in the temporary
buffer by clicking on the Re-Append images tool or the Confirmation tool.
Description
3A-43
Advertisement
Table of Contents
