Table of Contents
Advertisement
Scanner menu
Selecting the scanner
3B-22
The Scanner menu provides the following functions:
Select—accesses the Select dialog box which allows you to choose the
scanner you want to use. This is necessary when more than one scanner is
connected to the host PC or you are running in emulation mode.
Setup—accesses the Setup dialog box specific to the scanner you selected.
From this dialog box you can set specific parameters for the selected scanner.
Stop—stops the transport/feeder and disables the scanner. Keyboard
shortcut: F6
Start—enables the scanner and starts the transport/feeder or the flatbed.
Keyboard shortcut: F7
Select the scanner to use by accessing the Scanner Select dialog box.
1. Select Scanner>Select.
The Scanner Select dialog box appears.
The Auto detect scanner check box is enabled by default. If more than one
scanner is installed and connected to the host PC, uncheck the Auto detect
scanner check box and select the scanner you want to use from the Scanner
drop-down list.
When running in emulation mode, changing the scanner model changes the
scanner you are emulating.
2. Click OK.
3. Exit and restart Capture Software for any changes to take effect.
A-63054 February 2004
Advertisement
Table of Contents
