Table of Contents
Advertisement
10 Recovery Procedure
A-63054 February 2004
If for any reason Capture Software or the scanning PC shuts down or
terminates abnormally while scanning a batch, Capture Software will recover
and repair the batch at the time Capture Software is restarted and the batch
is reopened.
When restarting Capture Software after an abnormal termination, the Locked
Applications and Batches dialog box appears with any batches that were open
at the time of the abnormal termination.
When opening an abnormally terminated batch, the following message
appears in Capture Software.
• Click Yes to repair and open the batch. All pages that were successfully
scanned, processed, and displayed by Capture Software should still exist in
the batch. Pages that were scanned, but not processed and displayed by
Capture Software must be rescanned.
If you do not reopen and repair the affected batch upon restarting Capture
Software, Capture Software will allow you to open existing batches, create new
batches, and resume scanning within any application including the application
that contains the affected batch. However, if you attempt to run Application
Setup for the application that contains the affected batch, the following
message appears in Capture Software.
Here, Batch003 (as shown in the sample message box) is the batch that needs
to be repaired first.
10-1
Advertisement
Table of Contents
