Connection Instruction; Ntsc/Pal Analog Video; Ntsc/Pal+ Analog S-Video; Rgb Or Y.pb.pr. Analog Signals (Bnc Connector) - Ikegami MLW-2420C Instruction Manual

4. Input Signal Connection
For a standard type (without Optional input unit)

4-1. NTSC/PAL Analog Video

4-2. NTSC/PAL+ Analog S-Video

4-3. RGB or Y.Pb.Pr. Analog Signals (BNC Connector)

For G/Y signal : Connect to a component G/Y input.
For B/Pb.signal: Connect to a component B/Pb.input.
For R/Pr.signal : Connect to a component R/Pr. input
For Sync signal: Connect to a component Sync input

4-4. PC Analog signal

4-5. PC Digital signal

4-6. NTSC/PAL/HD Digital Video
Note that the termination of each input is automatic, however, please ensure you
Connect the input signal properly to an input connector, not an output connector, to
avoid incorrect operation.

4-7. Remote Connection

Remote control is possible with a remote control signal feed. The unit provides
a 9 pin D-sub connector on a rear panel. The connection is simple, but please
note that No.7 and No.8 pins of an input connector should be bridged.
And please consult your dealer or supplier for details.
LCD Monitor Rear Side/
D-SUB 9 pins Connector
Please ask the shop details.
: Connect to the Video input.
: Connect to the S-Video input.
: Connect to a PC input of D-Sub 15 pin connector.
: Connect to a DVI input.
: (Option) To SDT input.
:
* The PC side looping connects 7 pins and 8 pins.
6
:
The Outside PC/D-SUB
9 pins Connector