Operation; Input Selection And Controls; Symbols Display On A Screen - Ikegami MLW-2420C Instruction Manual

5. Operation

5-1. Input Selection and Controls

There are 6 keys on the front panel. Those are, (from left to right), input select
keys, SEL 1, SEL 2, SEL 3, and a Menu/Set key, Plus(+) key and Minus (-) key
and a front power switch and power indication LED on far right.
Input Select :
Those keys are to select an input signal for display and works as sequential
switch in order of VBS ---> S-Video ---> Component ---> PC --->DVI --->
VBS ---> S-Video - - - and goes back to VBS again.
SEL 1 : To select input signal of Component/SDI
SEL 2 : To select input signal of Video/S-Video
SEL 3 : To select input signal of PC/DVI
Menu/Set :
This is for a direct selection of Colour Pre-set, and when it is pressed for a long
period (more than 3 seconds ), it works to display the OSD Menu.
Plus (+) Key :
Normally for Contrast control and it works as a direct set control for (+),when
selecting setup menu.
Minus (-) Key :
Normally for Brightness control and it works as a direct set control for (-), when
selecting setup menu selection.
5-2. Display Symbols
COMPONENT :
SDI
VIDEO
S-VIDEO
PC
DVI
No Signal
Component
: M-SDI (optional unit)
: Video
: S-video
: PC input
: DVI input
: There is no input signal.
7