Ikegami MLW-2420C Instruction Manual page 20

• Clock:
• Phase :
• SAVE:
Note : Variable range of H.Position and V.Position when PAL or SDI signals
are fed ; H.Posi.
PAL -17 to + 17
SDI -50 to + 50
Also please note that the screen size can not be changed, when the clear mode is on.
NTSC/PAL
1600x1200 display
Black zone on both sides
HD
Black zone on top and bottom
This is to adjust a sampling dot number of Analog signals, other
than Video/S-Video, DVI signals.
(+) key to increase sampling frequency.
(-) key to decrease sampling frequency.
With component signal input or PC input, the optimum condi-
tion can be observed, by adjusting horizontal sampling dot num-
ber to match the dot number of input signal.
This is to adjust a sampling point of an input signal and may be
necessary to make it clear when edges are not clear when you
feed signals with characters or letters, or need to display fine
charts or drawings.
This works only with a component or PC.
This is to memorize the selected parameters. If you do not SAVE
the changes, the setting goes back to the conditions active prior
to making changes.
V.Posi.
-16 to +16
-10 to +10
Normal
1920x1200 display
Top and bottom cut off
1920x1200 display
1920x1080 display
Both sides cut off
14
Full Clear
1440 x 1080 display
1920 x 1080 display