Remote Connection; Rs-232C Terminal; Usb Terminal - Ikegami ML Series User Manual

4. Remote Connection

4.1 RS-232C terminal

Remote control is possible with a remote control signal feed.
D-SUB 9 pin connector on LCD Monitor back
1.
2.TXD
3.RXD
4.
5.GND
6.
7.
8.
9.
Do not connect anything to pins 1, 4, 6,
7, 8, or 9 on the monitor side (or else, a
malfunction of the monitor may occur).
Be sure to use a shielded cable for a remote signal cable. Please contact the sales agent
where you purchased the product for details.

4.2 USB terminal

It is used for updating the monitor control software.
CAUTION!
Please do not connect external device for maintenance. It may cause the faults or
mis-operation of the equipment.
External PC/D-SUB 9 pin Connector
Note: At the PC, Pins 7 and 8
must be loop-connected.
8
1.
2.RXD
3.TXD
4.
5.GND
6.
7.RTS
8.CTS
9.