Ikegami MLW-2420C Instruction Manual page 18

• DPMS:
This Display Power Management System is to save power consumption to
deactivate the Back Light when there is no input signal or no manipulation
after more than 30 seconds.
Pressing the power ON/OFF, or feed input signals, or key manipulation
resumes power.
• Back Light:
This is to set the level of back lighting of LCD panel.
0 means the lowest back light level and 255 is the highest.
• OSD Position:
This is to set the position of OSD.
1 is for upper left position, 2 is for upper right position, 3 is for lower left
position, 4 is for lower left position.
And 5 is for center position of the screen.
• OSD Under Time Out :
This is to set the desired time for auto-stop timing of OSD screen.
There are four positions and those are, 10s for 10 seconds, 30s for 30 sec-
onds, 60s for one minute and Off means this time out function is not active.
• Front Key Lock :
This makes the front panel control inoperative. By switching this ON, all
control via the front is deactivated.
To exit from the lock condition, and reactivate control ON press the (+) and
(-) keys at the same time.
• SAVE :
This causes all setting changes to be saved, without pressing Save the set-
ting goes back to the condition before setup manipulation.
12