Menu Setting And Key Operation - Ikegami MLW-2420C Instruction Manual

5-3. Menu setting and Key operation

The Setup Menu is showing presently input parameters and also setting func-
tion. It does not show when parameters are not input, or select to input.
5-3-1. Input signal Selection
Input signal selection is made by those keys, SEL 1, SEL 2 and SEL 3.
The last selected input is memorized and appears when powering on again.
SEL 1 : For input selection of Component and SDI
SEL 2 : For input selection of Video and S-Video
SEL 3 : For input selection of PC and DVI
Using a SELECT key, take a desired input signal.
This is sequential switch to have VBS ---> Y/C ---> COMPONENT
--->PC ---> DVI and turns to VBS again.
The last selected input before power off will be memorized and displayed when
powering again.
Input Select is for changing input signals and it works as sequential switch in
order of VBS ---> Y/C ---> COMPONENT ---> PC --->DVI and VBS again.
With an optional input unit, it changes its order to VBS ---> Y/C --->SDI.
The Selection key works as Toggle switch and it changes input by each press.
OSD control :
Input Select, Menu/Set is for showing OSD Menu and for a direct selection of
colour pre-set.
+/- is selection and setting for Setup Menu.
+ is for a direct control of Brightness, and - is for a direct control of Contrast.
POWER : For power On and Off.
8