4. Input Signal Connection
Connect the input signals in the following way.
4.1 NTSC/PAL Analog Video
4.2 NTSC/PAL Analog S-Video
4.3 RGB or YPbPr Analog signals
4.4 PC Digital signal
4.5 NTSC/PAL/HD Digital Video
Note: Various signal inputs (Video, S-Video and RGB) are automatically terminated. Be
sure to connect them to the input side because otherwise malfunction may occur.
4.6 Remote Connection
Remote control is possible with a remote control signal feed.
D-SUB 9 pin connector on LCD Monitor back
1.
2.TXD
3.RXD
4.
5.GND
6.
7.
8.
9.
Do not connect anything to pins 1, 4, 6,
7, 8, or 9 on the monitor side (or else, a
malfunction of the monitor may occur).
Be sure to use a shielded cable for a remote signal cable. Please contact the sales agent
where you purchased the product for details.
: Connected to the Video input.
: Connected to the S-Video input.
: Connected to PC input. (15P D-SUB connector)
: Connected to DVI input.
: Connected to SDI input.
7
External PC/D-SUB 9 pin Connector
Note: At the PC, Pins 7 and 8
must be loop-connected.
1.
2.RXD
3.TXD
4.
5.GND
6.
7.RTS
8.CTS
9.