Wpa(2)-Psk - ZyXEL Communications NBG-419N v2 User Manual

Table 37 WEP (WISP) (continued)
LABEL
Hex
Key 1 to Key 4
Apply
Cancel

10.5.2 WPA(2)-PSK

Use this screen if the access point to which you want to connect uses WPA(2)-PSK security mode.
Figure 60 WPA-PSK/WPA2-PSK (WISP)
The following table describes the labels in this screen. .
Table 38 WPA-PSK/WPA2-PSK (WISP)
LABEL
Wireless Setup
Network Name
(SSID)
Security
Encryption Type
Pre-Shared Key
Apply
Cancel
NBG-419N v2 User's Guide
DESCRIPTION
Select this option in order to enter hexadecimal characters as a WEP key.
The preceding "0x", that identifies a hexadecimal key, is entered automatically.
The WEP keys are used to encrypt data. Both the Router and the wireless stations must
use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure at least one key, only one key can be activated at any one time. The
default key is key 1.
Click Apply to save your changes back to the Router.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Enter the name of the access point to which you are connecting.
Select the type of wireless encryption employed by the access point to which you want to
connect.
WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type the pre-shared key employed by the access point to which you want to connect.
Click Apply to save your changes back to the Router.
Click Cancel to reload the previous configuration for this screen.
Chapter 10 WISP Mode
83