Note: You can enable the Wireless function of your Router by first turning on the switch in
the back panel.
Figure 41 Wireless Security
The following table describes the general wireless LAN labels in this screen.
Table 26 Wireless Security
LABEL
Wireless
Network Name
(SSID)
Security mode
Wireless
password
Verify password Type the password again to confirm.
Apply
Cancel
WPS
NBG-419N v2 User's Guide
DESCRIPTION
(Service Set IDentity) The SSID identifies the Service Set with which a wireless station is
associated. Wireless stations associating to the access point (AP) must have the same SSID.
Enter a descriptive name (up to 32 keyboard characters) for the wireless LAN.
Select WPA-PSK or WPA2-PSK to add security on this wireless network. The wireless
clients which want to associate to this network must have same wireless security settings as
this device. After you select to use a security, additional options appears in this screen.
Select No Security to allow any client to connect to this network without authentication.
This field appears when you choose wither WPA-PSK or WPA2-PSK as the security mode.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Click Apply to save your changes back to the Router.
Click Cancel to close this screen.
Click this to configure the WPS screen.
You can transfer the wireless settings configured here (Wireless Security screen) to
another wireless device that supports WPS.
Chapter 7 Easy Mode
59