Setting Your Router To Ap Mode; Accessing The Web Configurator In Access Point Mode - ZyXEL Communications NBG-419N v2 User Manual

Chapter 9 Access Point Mode

9.3.1 Setting your Router to AP Mode

Log into the Web Configurator if you haven't already. See the Quick start Guide for instructions on
1
how to do this.
To use your Router as an access point, go to Maintenance > Sys OP Mode > General and select
2
Access Point mode.
Figure 48 Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As soon
as you do, your Router is already in Access Point mode.
When you select Access Point Mode, the following pop-up message window appears.
3
Figure 49 Pop up for Access Point mode
Click OK. The Web Configurator refreshes once the change to Access Point mode is successful.

9.3.2 Accessing the Web Configurator in Access Point Mode

Log in to the Web Configurator in Access Point mode, do the following:
Connect your computer to the LAN port of the Router.
1
The default IP address of the Router is "192.168.1.2". In this case, your computer must have an IP
2
address in the range between "192.168.1.3" and "192.168.1.254".
Click Start > Run on your computer in Windows. Type "cmd" in the dialog box. Enter "ipconfig" to
3
show your computer's IP address. If your computer's IP address is not in the correct range then see
Appendix C on page 219
70
for information on changing your computer's IP address.
NBG-419N v2 User's Guide