Monitor Screen - ZyXEL Communications NBG-419N v2 User Manual

Chapter 22 Bandwidth Management
Table 75 Bandwidth Management Rule Configuration: User-defined Service
LABEL
BW Budget
Destination
Address
Destination
Subnet
Netmask
Destination
Port
Source Address
Source Subnet
Netmask
Source Port
Protocol
Apply
Cancel
See Appendix E on page 261

22.6 Monitor Screen

Use this screen to view the amount of network bandwidth that applications running in the network
are using.
The bandwidth is measured in kilobits per second (kbps).
166
DESCRIPTION
Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum or
minimum bandwidth allowed for the rule in kilobits per second.
Enter the IP address of the destination computer.
The Router applies bandwidth management to the service or application that is entering this
computer.
Enter the subnet netmask of the destination of the traffic for which the bandwidth
management rule applies.
This is the port number of the destination that define the traffic type, for example TCP port
80 defines web traffic.
Enter the IP address of the computer that initializes traffic for the application or service.
The Router applies bandwidth management to traffic initiating from this computer.
Enter the subnet netmask of the computer initiating the traffic for which the bandwidth
management rule applies.
This is the port number of the source that define the traffic type, for example TCP port 80
defines web traffic.
Select the protocol (TCP, UDP, User defined) for which the bandwidth management rule
applies.
If you select User-defined, enter the protocol for which the bandwidth management rule
applies. For example, ICMP for ping traffic.
Click Apply to save your customized settings.
Click Cancel to exit this screen without saving.
for commonly used services and port numbers.
NBG-419N v2 User's Guide