Chapter 5 To Trigger the Oscilloscope
RIGOL
Trigger Output Connector
The trigger output connector at the rear panel can output trigger signals determined
by the current setting.
Trigger Output Connector
When the oscilloscope is triggered, a signal that can reflect the current capture rate
of the oscilloscope will be outputted via [Trigger Out] connector and connect the
signal to a waveform display instrument to measure the frequency of the signal and
the result is equal to the current capture rate.
Note: in the
9 Pass/Fail
Test, when the Aux Out is turned on, there will be output a
negative pulse signal when failed waveforms are detected by the oscilloscope.
Connect this signal to other control systems to view the test result conveniently.
There will be output a 3.3 V CMOS high level when no failed waveform is detected by
the oscilloscope.
DS1000Z User's Guide
5-41