Rigol DS1000Z Series User Manual page 94

RIGOL
Setup Type:
Press SetupType to select the desired setup type.
Setup: set the time that the data stays stable and constant before the clock

edge appears. Press Setup to set the setup time and the range is from 8 ns to 1
s.
Hold: set the time that the data stays stable and constant after the clock edge

appears. Press Hold to set the hold time and the range is from 8 ns to 1 s.
SetupHold: set the time that the data stays stable and constant before and

after the clock edge appears. Press Setup and Hold to set the setup time and
hold time respectively and the range is from 8 ns to 1 s.
Trigger Mode:
Press Sweep to select the
normal or single. The corresponding status light of the current trigger mode turns on.
Trigger Setting:
Press Setting to set the trigger parameters (trigger holdoff and noise rejection)
under this trigger type.
Trigger Level:
Use TRIGGER
description of "Trigger
5-22
Trigger Mode
LEVEL to modify the level. For details, please refer to the
Level" on page 5-9.
Chapter 5 To Trigger the Oscilloscope
(page 5-3) under this trigger type as auto,
DS1000Z User's Guide