Displaying Traffic Data - Garmin Diamond DA40 Pilot's Manual

Integrated flight deck for da40 diamond star
Hide thumbs Also See for Diamond DA40:
Table of Contents

Advertisement

DISPLAYING TRAFFIC DATA

Traffic information is displayed on the following maps:
• PFD Inset Map
• Navigation Map Page
• Traffic Map Page
Displaying traffic on the Traffic Map Page:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Traffic Map Page.
3) Turn the RANGE Knob clockwise to display a larger area or counter-clockwise to display a smaller area.
Operating
Mode
Altitude
Mode
"Non-Bearing"
Traffic (Bearing
Undetermined),
Distance 8.0 nm,
1100' Above,
Descending
Off Scale
Traffic
The Traffic Map Page shows surrounding TAS traffic data in relation to the aircraft' s current position and
altitude, without basemap clutter. Aircraft orientation is always heading up unless there is no valid heading.
Map range is adjustable with the RANGE Knob from 2 to 24 nm, as indicated by the map range rings.
The traffic mode and altitude display mode are annunciated in the upper left corner.
190-00592-06 Rev. A
Figure 6-90 Traffic Map Page
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
HAZARD AVOIDANCE
• Trip Planning Page
• Nearest Pages
• Active Flight Plan Page
Traffic Display
Range
Traffic Advisory,
Aircraft is
400' Below,
Climbing
Proximity
Traffic, 1000'
Above,
Descending
349

Advertisement

Table of Contents
loading

This manual is also suitable for:

Diamond da40fG1000

Table of Contents