Table of Contents
Advertisement
ZOOM RANGE ON THE NAVIGATION MAP
Stormscope lightning data can be displayed up to 800 nm zoom range (in North up mode) on the Navigation
Map Page. However, in the track up mode at the 500 nm range, a portion of Stormscope lightning data
can be behind the aircraft and therefore not visible on the Navigation Map. Since the range for Stormscope
data is 400 nm diameter total (200 nm in front and 200 nm behind), the 500 nm range in North up mode
shows all the data.
At a map range of less than 25 nm, Stormscope lightning data is not displayed, but can still be present. The
presence of Stormscope lightning data is indicated by the annunciation 'LTNG < 25 nm' in the upper right
corner (Figure 6-49).
Selecting a Stormscope range on the Navigation Map:
1) Press the MENU Key.
2) Select 'MAP SETUP'.
3) Select the 'Weather' group.
4) Press the ENT Key.
5) Turn the large FMS Knob to select 'STRMSCP SMBL'.
6) Turn the small FMS Knob to select the maximum display range.
7) Press the ENT Key.
8) Press the FMS Knob to return to the Navigation Map Page.
To change the display range on the Navigation Map Page, turn the RANGE Knob clockwise to zoom out or
counter-clockwise to zoom in.
190-00592-06 Rev. A
Figure 6-48 Navigation Map Page Options Menu
Figure 6-49 Lightning Display Range Annunciation
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
HAZARD AVOIDANCE
309
Advertisement
Table of Contents
