Table of Contents
Advertisement
HAZARD AVOIDANCE
The traffic mode is annunciated in the upper left corner of the Traffic Map Page. When the aircraft is on the
ground, TIS automatically enters Standby Mode. If traffic is selected for display on another map while Standby
Mode is selected, the traffic display enabled icon is crossed out (also the case whenever TIS has failed). Once
the aircraft is airborne, TIS switches to Operating Mode and traffic information is displayed. The mode can be
changed manually using softkeys or the page menu.
Mode
TIS Operating
TIS Standby
TIS Failed*
* See Table 6-16 for additional failure annunciations
Switching between TIS modes:
1) Select the Traffic Map Page.
2) Press the STANDBY or OPERATE Softkey to switch between modes. The mode is displayed in the upper left
corner of the Traffic Map Page.
Or :
a) Press the MENU Key.
b) Select 'Operate Mode' or 'Standby Mode' (choice dependent on current state) and press the ENT Key.
346
Traffic Mode Annunciation
(Traffic Map Page)
OPERATING
STANDBY
(also shown in white in center of page)
FAIL
Table 6-15 TIS Modes
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
Traffic Display Enabled Icon
(Other Maps)
190-00592-06 Rev. A
Advertisement
Table of Contents
