Table of Contents
Advertisement
SYSTEM STATUS
The G1000 performs an automatic test of TIS during power-up. If TIS passes the test, TIS enters Standby
Mode (on the ground) or Operating Mode (in the air). If TIS fails the power up test, an annunciation is shown
in the center of the Traffic Map Page.
System Test has Failed
190-00592-06 Rev. A
Traffic Map Page
Annunciation
NO DATA
Data is not being received from the transponder*
Data is being received from the transponder, but
DATA FAILED
a failure is detected in the data stream*
FAILED
The transponder has failed*
UNAVAILABLE
TIS is unavailable or out of range
* Contact a service center or Garmin dealer for corrective action
Table 6-14 TIS Failure Annunciations
Figure 6-89 TIS Power-up Test Failure
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
HAZARD AVOIDANCE
Description
Data Not Received
from Transponder
345
Advertisement
Table of Contents
