Xerox 4595 User Manual page 384

11 . P r ob l e m S ol v i n g
The Printed Result is not what was Expected
No stapling done
No
No folding
No
Printing performed with
a different paper size
The image is cut off on
the edge of the paper
No
The printed font differs
from the font specified
on the computer
No
Printing is slow
No
11 - 2 2
This section describes solutions for situations in which the print
result is different from that expected.
The number of pages to staple exceeds 100 or the
Cause
number exceeds 50 with staple cartridge for 50
sheets.
Staple-enabled number of pages is 50 or lower with
Action
the staple cartridge for 50 sheets and 100 or lower
with the staple cartridge for 100 sheets. For Z-folding,
staple-enabled number of pages is 10 or 5 sheets
depending on the size of the paper used. For
booklet, up to 15 sheets can be stapled at one
time. Reduce the number of printed pages to 50 or
100 or lower, depending on the staple cartridge used.
The folder is not attached.
Cause
Check the options attached with this printer, and
Action
reset the printer configuration
Paper size provided is different from the specified
Cause
tray size.
Change the paper size set in the tray, or change print
Action
options to specify a tray that contains the appropriate
size.
Image exceeds the printable area of the machine.
Cause
Increase the printable area of the machine, or
Action
decrease the document print area.
Font replacement is configured on the print driver.
Cause
Check the font replacement table.
Action
Non-standard fonts are used for printing.
Cause
Check the application or print driver settings.
Action
If PostScript is being used, download the required
fonts.
The print mode specifies Print Quality.
Cause
When printing image data that has image quality as a
Action
priority, such as pictures, the print speed decreases.
Turn off the quality priority in the print mode.
X er o x 4 5 95 C op i e r /P r i n te r U s er G ui d e