Mixed Size Originals - Xerox 4595 User Manual

X er o x 4 5 95 Co pi e r /P r i n te r U s e r G u i de
Select Save to save the changes.
3.
Auto Size Detect
Scan sizes are detected automatically.
NOTE: If the document size cannot be detected, a screen to input
the document size appears.
Standard size
Select from the preset size buttons.
You can change the indicated document sizes. For information
about the setting procedure, refer to "Original Size Defaults" in the
System Administration Guide.
Non-Standard Size
Use the area at the right of the screen to enter the desired scan
size when scanning non-standard size documents or when
making copies at a size different from that of the currently loaded
document. The size can be specified in 0.1 inch or 1 mm
increments within the range from 0.6 to 17.0 inches (15 to 432
mm) for the width (X) on the document glass and within the range
from 0.6 to 11.6 inches (15 to 297 mm) for the height (Y) on the
document glass. The scale on the outside of the document glass
is a useful reference for specifying the document size.

Mixed Size Originals

You can simultaneously scan different sized documents. Output
can be made to media the same size as the originals or so that
output is made on the same size of media no matter the size of the
original.
KEY POINT: Be sure to load A5 documents in Long Edge Feed
orientation.
When loading a B5 size document with A3 or 8.5 x 11 in./
A4 size documents in a vertical direction, place the B5
document also in a vertical direction.
The recommended combinations of documents are 8.5 x
11 inch/A4 portrait and11 x 17 inch/A3 landscape or B5
portrait and B4 landscape. If you combine documents with
sizes other than the ones just stipulated, the documents
may not feed correctly or scan properly.
2. Co p y
2-35