D2 Finisher - Xerox 4595 User Manual

X er o x 4 5 95 Co pi e r /P r i n te r U s e r G u i de
Close the Finisher right cover.
8.
NOTE: A message will be displayed and the machine will not
operate if the right cover is even slightly open.
If the staples cannot be removed after carrying out the above
procedures, contact the Customer Support Center.

D2 Finisher

The following section describes the remedy for staple jams in the
staple cartridge for the D2 Finisher.
Make sure that the machine has stopped and then open the
1.
front cover on the light finisher.
Hold the R1 at the position shown in the diagram and lift it
2.
slightly.
Pull out the staple cartridge.
3.
NOTE: After removing the staple cartridge, check the inside of the
finisher for any remaining staples.
Open the staple cartridge cover and remove the jammed
4.
staple.
5. If the jammed staple cannot be removed, push the staple in
WARNING: Be careful when
removing jammed staples to
avoid hurting your fingers.
11 . P r o b le m S o l vi n g
11-87