Navigator Setup; Navigation Data Source - Furuno 1722C Operator's Manual

5.7

Navigator Setup

This section provides the information necessary for selecting the type of
navigator connected to your plotter.
5.7.1 Navigation data
source
The NAV SETUP menu
mainly selects the source
of nav data. For GPS
receiver other than the
GP-310B, speed averaging
and local time offset (to use
local time) are also
available. Press the
[MENU] key followed by the
SYSTEM
CONFIGURATION, NAV
OPTION and NAV
SOURCE SETTINGS soft
keys to display this menu.
Item
Position Chooses source of position data.
Source
Speed Calculation of ETA is based on average ship's
Averaging speed over a given period. If the period is too long
or too short, calculation error will result. Change
this setting if calculation error occurs. The default
setting is suitable for most conditions.
Local Time GPS uses UTC time. If you would rather use local
Offset time, enter the time difference between it and
UTC. Use the +<-->- soft key to switch from plus to
minus and vice versa.
Temp Offsets NMEA water temperature data.
Calibration
Depth Offsets NMEA depth data.
Calibration
POSITION SOURCE
ALL
SPEED AVERAGING*
LOCAL TIME OFFSET*
TEMP CALIBRATION
DEPTH CALIBRATION
Contents of nav setup menu
Description
5. CUSTOMIZING YOUR UNIT
NAV
SETUP
EDIT
0060
+00:00
00 ° F
00ft
RETURN
Settings
FURUNO BB GPS: GPS
Receiver GP-310B
GP: GPS navigator (via
NETWORK or NMEA connector)
LC: Loran C navigator (via
NETWORK or NMEA connector)
All: Multiple navaid connection
( via NETWORK or NMEA
connector)
0-9999 sec
-13:30 to +13:30
-40°F - + 40°F
-15 - +90 ft
* For GPS receiver other
than GP-310B.
Nav setup menu
Default
Setting
ALL
60 sec
00:00
0°F
0 ft
5-23