Sensor Setup - Furuno 1722C Operator's Manual

5.9.2

Sensor setup

The sensor setup menu lets you further refine speed, temperature and depth
data fed from the network sounder.
1. Show the sounder display and press the [MENU] key.
2. Press the SOUNDER SYSTEM SETUP and SENSOR SETUP soft keys to
show the SENSOR SETUP menu. The current ship's speed, water
temperature, depth and speed of sound are shown at the bottom of the
menu.
3. Select item to adjust and press the EDIT soft key.
4. Use the cursor pad to display appropriate value as below.
Speed and temperature calibrations: Enter plus or minus value. For
example, if the water temperature readout is 77 F but the actual water
temperature is 75 F, enter –2( F).
Depth calibration: If you desire the depth readout to show the distance
between ship's draft and bottom (rather than transducer and bottom), set
ship's draft here. Enter a plus or minus value.
Acoustic speed calibration: Sets the speed of sound used by the network
sounder. Note that this is only used if water salinity is at an extreme level.
Under normal circumstances, do not adjust.
Speed Calibration
Temperature Calibration
Depth Calibration
Acoustic Speed Calibration
5. Press the RETURN soft key followed by the [MENU] key to close the menu.
SPEED CALIBRATION
+ 00%
TEMP CALIBRATION
+ 0 F
DEPTH CALIBRATION
+0.0ft
ASCTC SPD CALIBRATION
+ 000m/s
SPEED
12.3kt
DEPTH
125.0ft
Sensor setup menu
Sensor setup menu settings
Item
-50 -+50%
-40 F - +40 F
-5 - +60 (any unit of
measurement)
-500 - +500 m/s
5. CUSTOMIZING YOUR UNIT
SENSOR
SETUP
EDIT
RETURN
TEMP
78.8 F
ACSTC SPD
1500m/s
Settings
0 (no offset)
0 (no offset)
0 (no offset)
0(m/s)
Default Setting
5-31