Table of Contents
Advertisement
2.
INITIAL SETUP
2.1
Check Points After Installation
Before using the product, carry out the following:
• Mechanical checks
• Turning the power on and initial setup
Mechanical checks
Check below points before switching on the DRS2D-NXT/DRS4D-NXT.
• All washers are in place and bolts are fully fastened.
• All connections are secure and LAN connector of the cable assembly is connected
to the multi function display device.
Turning the power on and initial setup
Use the information in this manual and the manual for multi function display device to
proceed with initial setup.
1. Ensure that all personnel are clear of the antenna.
2. Turn on the multi function display device.
3. Take the appropriate action on your multi function display device to start transmis-
sion.
4. Check if the heading is correctly aligned - targets should appear at their correct
bearing relative to the boat's bow. Adjust the alignment if necessary, referring to
section 2.2.
2.2
Initial Setup
Turn on the multi function display device, and do the initial setup for the radar sensor.
2.2.1
Initial setup for TZTL12F/TZTL15F/TZT2BB/TZT9F/TZT12F/
TZT16F/TZT19F
1. Tap the [Home] icon to show the home screen and display mode settings.
2. Tap [Radar] from the [Settings] menu.
3. Tap [Radar Source], then select the appropriate antenna unit.
Note: If an antenna unit is connected but does not appear in the [Radar Source]
list, close the list and open it again. The name of the antenna unit should appear
with a check mark, as in the example below.
4. Drag the [Radar] menu display to show the [Radar Initial Setup] menu.
xxxxxxxx-xxxxxxxxxx
8
Advertisement
Table of Contents
