Entering The Mob Mark, Setting Mob As Destination - Furuno 1722C Operator's Manual

3.13 Entering the MOB Mark, Setting MOB as
Destination
The MOB (Man Overboard) mark functions to mark man overboard position. You
can inscribe this mark from any mode, except while playing back data or
conducting a self-test. Note that this function requires position data.
1. Press and hold down the [SAVE/MOB] key for about three seconds when
someone falls onboard. The display shows the waypoint number being saved
(youngest empty waypoint number, 001-999) followed by the MOB
confirmation window.
XXX = Waypoint number
2. Push the [ENTER] knob to select the MOB position as the destination, or
press the [CLEAR] key to only mark current ship's position as a waypoint. If
you select the MOB position as destination;
A full-screen radar, plotter or overlay (color model only) appears depending on
the display in use.
The MOB mark "MOB" appears at the MOB position and a line runs between it
and current position. This line shows the shortest course to the MOB position.
Range and bearing to the MOB position are shown in the MOB data box.
To erase an MOB mark from the plotter display, you must first erase its
corresponding waypoint. Place the cursor on the MOB mark, then press the
[CLEAR] key followed by pushing the [ENTER] knob to erase the waypoint. Then,
repeat to erase the MOB mark..
Range, bearing
Current
Man
overboad position
MOB concept
WAYPOINT SAVED!
XXXWPT
CONTINUE PUSHING
FOR MOB!
MOB mark messages
3. PLOTTER OPERATION
MOB
mark
M
(MOB)
M
162.5
O
0.49 nm
B
MOB Data Box
Bearing and range
to MOB position
MAN OVER BOARD!
GO TO MOB?
YES ... PUSH ENTER KNOB
After
NO ... PUSH CLEAR KEY
several
seconds
3-61