Setting Vector Attributes (Arp) - Furuno 1722C Operator's Manual

2.25.5

Setting vector attributes (ARP)

What is a vector?
A vector is a line extending from a tracked target which shows estimated speed
and course of the target. The vector tip shows an estimated position of the target
after the selected vector time elapses. It can be useful to extend the vector
length in order to evaluate the risk of collision with any target.
Vector reference, vector time
You may reference the vectors to North (True) or ship's heading (relative) as
desired. Vector time can be set to 30 seconds, 1, 3, 6, 15 or 30 minutes.
1. Press the [MENU] key followed by the ARP SETUP soft key to show the ARP
SETUP menu.
2. Operate the cursor pad to select ARP VECTOR MODE.
3. Press the EDIT soft key to show the vector mode window.
4. Select TRUE or RELATIVE as appropriate.
5. Press the ENTER soft key.
6. Select ARP VECTOR TIME, and then press the EDIT soft key to show the
ARP vector time window.
7. Operate the cursor pad to select vector time among 30 sec, 1 min, 3 min, 6
min, 15 min and 30 min.
8. Press the ENTER soft key.
9. Press the [MENU] key to close the menu.
Vector
Vector
ARP VECTOR MODE
¤
RELATIVE
¡
TRUE
Vector mode window
ARP VECTOR TIME
¤
30 seconds
¡
1 minute
¡
3 minutes
¡
6 minutes
¡
15 minutes
¡
30 minutes
ARP vector time window
2. RADAR OPERATION
2-39