Resetting Trip Distance - Furuno 1722C Operator's Manual

3. PLOTTER OPERATION
Alarm messages
The table below shows the plotter alarm messages and their meanings
ARRIVED AT XXX WAYPOINT!
(XXX = waypoint number)
ENTERED INTO AVOIDANCE
AREA!
EXCEEDED ANCHOR WATCH
LIMIT!
EXCEEDED XTE LIMIT!
SPEED ALARM!
TEMPERATURE ALARM!
TRIP ALARM! MILEAGE
EXCEEDED
3.12

Resetting Trip Distance

Trip distance is shown on the navigation data display. You can reset the trip
distance to zero as follows:
1. Press the [MENU] key.
2. Press the SYSTEM CONFIGURATION and GENERAL SETUP soft keys in
that order to show the GENERAL SETUP menu.
3. Use the cursor pad to select RESET TRIP LOG and press the EDIT soft key.
4. Use the cursor pad to select YES.
5. Press the ENTER soft key.
6. Press the [MENU] key to close the menu.
3-60
Plotter alarm messages and their meanings
Message
KEY BEEP
ON
LANGUAGE
ENGLISH
RANGE UNIT
nm, kt
TEMPERATURE UNIT
F
DEPTH UNIT
ft
TEMPERATURE SOURCE
NMEA
DEPTH SOURCE
NMEA
RESET TRIP LOG
NO
General setup menu, page 1
Meaning
Arrival alarm violated.
Proximity alarm violated.
Anchor watch alarm violated.
XTE alarm violated.
Speed alarm violated.
Water temperature alarm
violated.
Trip alarm violated.
GENERAL
SETUP1
EDIT
NEXT
PAGE
RETURN