Selecting Radar Source - Furuno 1722C Operator's Manual

1. OPERATIONAL OVERVIEW
1.6.4

Selecting radar source

When other network radar is connected to the equipment, you may select an
image source as shown below. This is not necessary when no other network
radar is connected. Select one host name for the source though there are two or
three radar units on the net.
Note: Turn the power off whenever changing the source.
1. Press the [DISP] key.
2. Press any soft key to show the following display.
3. Use the cursor pad to select RADAR SOURCE and press the EDIT key.
4. Use the cursor pad and [ENTER] knob to enter source host name: ◄ or ► to
select position and rotate the [ENTER] knob to select character.
5. Press the [ENTER] soft key or [ENTER] knob.
6. Confirm that the correct host name is entered.
7. Press the [DISP] key to finish.
8. Turn the power off and on again.
Note: Sources names are determined at installation. For example, the source
names for radars in a two radar system might be "RADAR" and
"RADAR1".
1-14
RADAR SOURCE
RADAR - - -
SOUNDER SOURCE*
SOUNDER -
IP ADDRESS
172.031.003.001
HOST NAME
RADAR - - -
IF THERE IS MORE THAN
ONE NETWORK RADAR OR
ECHO SOUNDER, YOU MAY
SELECT THE IMAGE
SOURCES FOR DISPLAY.
Select source menu
RADAR SOURCE
RADAR - - -
Radar source
Radar source and sounder source windows
SELECT
SOURCE
EDIT
RETURN
*: Do not change this setting.