Ps Pcb Unit - Brother DCP7010 Service Manual

(11) Remove the two cup S M3x6 taptite screws.
(12) Disconnect the three connectors from the PS PCB unit, and then remove the PS PCB unit.
Main frame R
NOTE: When disconnecting the connectors, disconnect the regist sensor PCB connector
and toner LED PCB unit ASSY connector first, lift up the PS PCB unit from the
LV shield plate, and disconnect the main PCB connector.

PS PCB unit

Toner LED PCB unit
ASSY connector
5 -5 3
LV shield plate
PS PCB unit
Taptite, cup S M3x6
Main PCB connector
Regist sensor PCB connector
Taptite, cup S M3x6
Confidential