Brother DCP7010 Service Manual page 262

EEPROM CUSTOMIZING CODES
This function allows you to customize the EEPROM according to language, function settings, and
firmware switch settings.
Operating Procedure
(1) Press the Menu/Set (Menu) and Start keys. Next press the
machine
enter the maintenance mode.
TIP: FAX models equipped with numerical keypads can enter the maintenance mode in the
same way as conventional models; that is, by pressing the Menu/Set, *, 2, 8, 6 and 4
keys in this sequence.
The machine beeps for approx. one second and displays "
LCD.
(2) MFC7420/7820N
Press the 7 and 4 keys in this order in the initial stage of the maintenance mode.
DCP7010/7020/7025
Enter 7 and 4 in the initial stage of the maintenance mode by using
(*To enter a numerical code on models having no numerical keypad, press the
display the numerical code to be entered and then press the Set key. Repeat this operation for each
numerical code.)
The current customizing code appears (e.g., 8001 in the case of MFC7420 U.S.A. model).
(3) Enter the desired customizing code (e.g., 0002 in the case of MFC7420 CANADA model).
The newly entered code appears.
MFC7420/7820N
To enter letters "A" through "F," press the 1 through 6 keys while holding down the # key,
respectively.
DCP7010/7020/7025
To enter the customizing code by using the
NOTE: If a wrong 4-digit code is entered, the machine will malfunction.
(4) Press the Start key.
The machine saves the setting and returns to the initial stage of the maintenance mode.
If you press the Stop/Exit key or no keys are pressed for one minute in the above procedure,
the machine stops the procedure and returns to the initial stage of the maintenance mode.
and Set keys.*
App. 3-1
key four times to make the
" on the
and Set keys.*
key several times to
Confidential