Laser Unit And Toner Sensor Pcb - Brother IntelliFax-2600 Service Manual

1.11 Laser Unit and Toner Sensor PCB

(1) Remove the screw (Taptite, cup B M3x8) from the toner sensor PCB.
(2) Slightly lift up the toner sensor PCB and disconnect its harness.
(3) Remove the three screws from the laser unit.
(4) Slightly lift up the laser unit and disconnect the following from the main PCB:
- Laser diode harness (5-pin)
- Toner sensor harness (4-pin) if the toner sensor PCB is installed
- Polygon motor flat cable
NOTE: When handling the laser unit, take care not to touch the inside of the unit, glass, or
mirror.
NOTE: On the small PCB at the right side of the laser unit is a 2-pin connector which is for the
adjustment in the factory. Do not disturb it.
Reassembling Notes
• Before putting the laser unit back into place, check for any toner particles, paper dust or dirt, and
clean them out.
• When installing the laser unit, make sure that the laser diode harness, toner sensor harness and
polygon motor flat cable are routed as shown above.
• Make sure that the sponge is placed below the laser unit.
IV - 27