Brother DCP7010 Service Manual page 191

ERROR MESSAGE
Machine too Hot
No Cartridge
No Paper Fed
No Response/Busy
Not Registered
Out of Memory
Paper Jam Inside
Paper Jam Rear
Paper Jam Tray
CAUSE
The inside of the machine is too
hot.
The toner cartridge is not installed
properly.
The MFC is out of paper or paper
is not properly loaded in the paper
tray.
The paper is jammed in the MFC.
The number you dialed does not
answer or is busy.
You tried to access a One-Touch
or Speed Dial number that is not
programmed.
The MFC's memory is full.
The paper is jammed inside the
MFC.
The paper is jammed in the back
of the MFC.
The paper is jammed in the paper
tray of MFC.
9 -3
ACTION
Make sure that the fan in the MFC is
spinning and the exhaust outlet is not
blocked by something. If the fan is
spinning, remove some obstacles
around the exhaust outlet, and then
leave the MFC turned on but do not use
it for several minutes. If the fan is not
spinning, you need to save the faxes
before you follow the suggestions
below. Then, turn off the MFC and
then on again.
Reinstall the toner cartridge.
Refill the paper in the paper tray.
—OR—
Remove the paper and load it again.
Remove the jammed paper.
Verify the number and try again.
Set up the One-Touch or Speed Dial
number.
(Fax sending or copy operation in
progress)
Press Start to send or copy the scanned
pages.
—OR—
Press Stop/Exit and wait until the other
operations in progress have finished
and then try again.
—OR—
Clear the faxes from the memory.
(Printing operation in process)
Reduce print resolution.
(See Advanced tab in Software User's
Guide on the CD-ROM.)
—OR—
Clear the faxes from the memory.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Confidential