Brother DCP7010 Service Manual page 303

Selector
No.
ECP mode*
1
(Not used.)
Recovery from Inactive PC
2 Interface
(Not used.)
PC Power-off Recognition
3 Time
(Not used.)
4 Not used.
5 Escape from phase C
Extension of incoming calling
6
signal (CI) frequency band
|
specified by selectors 1
8
through 4 on WSW14
Selector 1: ECP mode (Not used.)
The ECP mode enhances the normal bidirectional communications between the machine and the
connected PC for higher transmission speed.
Selector 2: Recovery from Inactive PC Interface (Not used.)
If the machine recognizes via the STB signal line that the connected PC is powered off, it will turn
the PC interface outputs Low to protect the PC from hazards that could be caused by weak electric
current accidentally flown from the machine.
This selector determines whether or not the machine should recover from the inactive PC interface
to normal interfacing state upon receipt of data from the PC.
Selector 3: PC Power-off Recognition Time (Not used.)
This selector sets the time length from when the machine detects the PC powered off until it
recognizes the detected state as power-off.
If selector 2 is set to "0," it is recommended that selector 3 be set to "1"; otherwise, the machine
may mistakenly detect PC powered off.
Selector 5: Escape from phase C
This selector determines whether or not the machine will escape from phase C when it detects an
RTC (Return to Control) in non-ECM mode or an RCP (Return to Control Partial page) in ECM
mode.
WSW36
(Function setting 14)
Function
App. 4-40
Setting and Specifications
0: ON 1:
0: Disable 1:
0: Normal 1:
0: Yes 1:
No. 6 7 8
0 0 0 : 0 (Ignored)
0 0 1 : 4 (448 Hz)
0 1 0 : 8 (244 Hz)
0 1 1 : 12 (162 Hz)
1 0 0 : 16 (122 Hz)
1 0 1 : 20 (97 Hz)
1 1 0 : 24 (81 Hz)
1 1 1 : 28 (69 Hz)
OFF
Enable
Long
No
*ECP (Enhanced Capabilities Port)
Confidential