Disabling A Vlan On A Converged Interface; Configuring Protocol-Based Vlan Classifier Rules - Brocade Communications Systems Converged Enhanced Ethernet 8000 Administrator's Manual

6

Configuring protocol-based VLAN classifier rules

6. Enter the switchport converged allowed vlan add vlan_id command to give access to individual

Disabling a VLAN on a converged interface

To disable a VLAN on a converged interface, perform the following steps from privileged EXEC
mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the no shutdown command to enable the CEE interface.
4. Enter the switchport command to place the CEE interface into converged mode.
5. Enter the switchport trunk allowed vlan remove vlan_id command to disable a VLAN on a

Configuring protocol-based VLAN classifier rules

You can configure VLAN classifier rules to define specific rules for classifying frames to selected
VLANs based on protocol and MAC addresses. Sets of rules can be grouped into VLAN classifier
groups (see
VLAN classifier rules (1 through 256) are a set of configurable rules that reside in one of these
categories:
•
•
•
NOTE
Multiple VLAN classifier rules can be applied per interface provided the resulting VLAN IDs are
unique for the different rules.
802.1Q protocol-based VLANs apply only to untagged frames, or frames with priority tagging.
With both Ethernet-II and 802.2 SNAP encapsulated frames, the following protocol types are
supported:
•
•
•
52
DRAFT: BROCADE CONFIDENTIAL
VLANs.
switch(conf-if-te-0/1)#switchport converged allowed vlan add 200
switch(conf-if-te-0/1)#switchport converged allowed vlan add 300
switch(conf-if-te-0/1)#switchport converged allowed vlan add 400
switch(config)#interface tengigabitethernet 0/10
switch(conf-if-te-0/10)#switchport mode converged none
converged interface.
switch(conf-if-te-0/10)#switchport trunk allowed vlan remove 300
"Creating a VLAN classifier group and adding rules"
802.1Q protocol-based classifier rules
Source MAC address-based classifier rules
Encapsulated Ethernet classifier rules
Ethernet hexadecimal (0x0000 through 0xffff)
Address Resolution Protocol (ARP)
IP version 6 (IPv6)
on page 53).
Converged Enhanced Ethernet Administrator's Guide
53-1002163-02