Using The Do Command As A Shortcut; Displaying Cee Cli Commands And Command Syntax - Brocade Communications Systems Converged Enhanced Ethernet 8000 Administrator's Manual

2
CEE Command Line Interface
NOTE
In EXEC and privileged EXEC modes, use the show history command to list the commands most
recently entered. The switch retains the history of the last 1000 commands entered.

Using the do command as a shortcut

You can use the do command to save time when you are working in any configuration mode and
you want to run a command in EXEC or privileged EXEC mode.
For example, if you are configuring an LLDP and you want to execute a privileged EXEC mode
command, such as the dir command, you would first have to exit the LLDP configuration mode.
However, by using the do command with the dir command, you can ignore the need to change
configuration modes, as shown in the following example.
switch(conf-lldp)#do dir
Contents of flash://

Displaying CEE CLI commands and command syntax

Enter a question mark (?) in any command mode to display the list of commands available in that
mode.
switch>?
Exec commands:
enable
exit
help
logout
quit
show
terminal
To display a list of commands that start with the same characters, type the characters followed by
the question mark (?).
switch>e?
enable
exit
To display the keywords and arguments associated with a command, enter the keyword followed by
the question mark (?).
switch#terminal ?
length
no
If the question mark (?) is typed within an incomplete keyword, and the keyword is the only keyword
starting with those characters, the CLI displays help for that keyword only.
switch#show d?
dot1x
<cr>
18
DRAFT: BROCADE CONFIDENTIAL
-rw-r-----
-rw-r-----
-rw-r-----
-rw-r-----
Turn on privileged mode command
End current mode and down to previous mode
Description of the interactive help system
Exit from the EXEC
Exit current mode and down to previous mode
Show running system information
Set terminal line parameters
Turn on privileged mode command
End current mode and down to previous mode
Set number of lines on a screen
Negate a command or set its defaults
IEEE 802.1X Port-Based Access Control
1276 Wed Feb 4 07:08:49 2009
1276 Wed Feb 4 07:10:30 2009
1276 Wed Feb 4 07:12:33 2009
1276 Wed Feb 4 10:48:59 2009
Converged Enhanced Ethernet Administrator's Guide
startup_rmon_config
rmon_config
rmon_configuration
starup-config
53-1002163-02